HOW TO MAKE A PORCH CHAIR
The illustration shows a very comfortable and attractive porch chair
that can be made with few tools and easily procured material. Most any
kind of wood will answer, says the American Carpenter and Builder, but
if open grained wood, such as oak or chestnut, is used, the parts should
be filled with a paste filler. If the natural color of the wood is not
desired, the wood may first be stained, the filler being colored
somewhat darker than the stain.
Porch Chair Finished
Procure enough lumber to make all the pieces shown in the detail drawing
and finish to the dimensions shown, being careful to make the
corresponding pieces exactly alike in order to preserve the perfect
symmetry which is necessary in work of this kind. In boring the holes
care must be taken to keep both edges of the holes sharp and clean. The
holes should each be bored until the spur shows; the bit should then be
withdrawn and the rest of the boring be done from the other side. The
semicircular notches are made by placing the two pieces edge to edge in
the vise and placing the spur of the bit in the crack. The 1-in. bit is
used. As it will be difficult to finish the boring of these blocks from
the second side, the parts remaining may be cut out with the knife after
the pieces have been separated.
Five 1/2-in. dowel rods are needed. It is possible to get these in one
long piece if you happen to live near a mill and then all you will have
to do is to saw off the desired lengths. However, if they cannot be got
easily you can make your own. Two [16]
rods each 18-1/4 in. long; two rods each 20-1/4 in. and one rod 22-1/4 in. give the exact lengths. It is
well to cut each piece a little longer than required so that the ends
which are imperfectly formed may be cut off. These rods should fit tight
and may be fastened in addition with a small screw or nail from the under or back side.
[17]
The hand rests should be nailed to the arms with small nails or brads
before the arms are bolted. The illustration of the assembled chair
shows the relative position.
The bolts should be 1/4 in. and of the following lengths: 4 bolts 2-1/4
in. long; 2 bolts 2 in. long; 2 bolts 3 in. long. Washers should be
placed between adjacent pieces of wood fastened together with bolts and
also at both ends of the bolts. This will require 26 washers in all.
While the size of the chair may be varied, it will be necessary to keep
the proportions if the parts are to fold properly.
